Expert talks to replace the Hall Motor and Motor of Intelligent Airwheel A3 saddle-equipped electric scooter

Veröffentlicht von: SEO Wizrad
Veröffentlicht am: 28.03.2016 12:05
Rubrik: Handel & Wirtschaft


(Presseportal openBroadcast) - One of the innovative product is Airwheel A3 saddle-equipped electric scooter. With a saddle, a long journey is care free and labour saving. The growing prosperity of Airwheel self-balancing electric scooter let a host of characters not only know it, but also ride it to facilitate daily commuting. There is an expert, explaining how to replace the Hall Motor and Motor of Airwheel A3.

Firstly, there are several methods of how to identify whether Hall elements have been damaged

Power on, alarm appears and there is “!” flashing in the lower right of screen.

Observe the red light on the driver board; if it is each five times of flashes with pause once, then it is the Hall’s fault.

Use instrument to connect with motor, and rotate the three red lights of motor. Watch it if three red lights flash in sequence.

Replace the Hall of Motor of Airwheel A3 self-balancing two wheels scooter: disassemble it referring to video; Remove the three damaged halls of motor in order; Clean and remove the residual fragments. Install new halls of motor, and use glue to make it fixed. Add stannum to weld. Install the rest halls by the same way as the above. Use air pump to clean up the remaining fragments and dust. Use instrument to check it. If you rotate the wheel, and three lights flash in sequence, it means it is repaired well. Make installation refer to video.

Replace motor of Airwheel A3 sitting posture self-balancing scooter. Please take off the battery before disassembling it referring to video. Take photos to keep records of switches position corresponding the plug wires before you take them off. Disassemble it according to video. Take photos for keeping records before taking wires off. After finishing disassembling the motor, go on the following steps. Install them referring to video, and sort out flat cables to avoid being squeezed.

Media Contact
Company Name: Airwheel Technology Holding (USA) Co., Ltd
Contact Person: Eric
Address: Los Angeles, California, USA
E-mail: business@airwheel.net
Website: http://www.airwheel.net

Bitte beachten Sie, dass für den Inhalt der hier veröffentlichten Meldung nicht openBroadcast verantwortlich ist, sondern der Verfasser der jeweiligen Meldung selbst. AGB | Haftungsausschluss.